This just supplies +/- 12V for Eurorack modulars.
Andrew's build notes are here:
Ok, lets twerk
The PCB receives 12VAC from a plugpack/ wallwart
. The 1N4004 diodes split this into positive and negative waveforms.
The 4700uF capacitors then smooth out these waves
. The 7812 and 7912 regulators then convert the rectified & smoothed
signals to +12V DC and -12V DC and these are fed to the connectors to be distributed to your lovely modules.
I'm using 250v TDK film caps for the four small 100nf caps
Probably a bit overkill, but it's what i had in stock at the time.
Some pics of the 7812 & L7912 voltage regulators attached to various heatsinks.
He also recommended using heatsink paste.
25V caps are okay but better to get 35V or 50V rating. just to keep the action well clear of the edge.
Always bigger is better with heatsinks, smaller ones cant soak off so much heat so will limit the current output of the regs. With a small one you will only get 3-400mA, a big one will get you double that (roughly...very)
They do appear to be pretty close in the pics.
My sinks don't appear to get hot but they could cause problems if the temp exceeds the cap ratings.
These caps have a rating of 105 degrees celsius.